Peugeot 3008 1.2 PureTech Engine Replacement Compare Prices & Get Quotes

A rebuilt Peugeot 3008 1.2 PureTech engine typically costs **£1,200-£3,200** supply-only, depending on power output and condition. EB2ADT 110hp units start around **£1,200**, while EP5/HNS 130hp units range **£1,500-£3,200**. Used engines start from **£600**. Supply & fit adds **£400-£900** labour. Peugeot dealer replacement can exceed **£6,500**. Check Peugeot's Customer Support Programme - you may be entitled to 100% coverage.

• Rebuilt EB2ADT: £1,200-£2,400
• Rebuilt EP5/HNS: £1,500-£3,200
• Used engines: £600-£1,400

The low oil pressure warning on Peugeot 3008 1.2 PureTech engines is caused by **wet timing belt degradation**. The belt runs inside the engine, exposed to heat and oil, and sheds rubber particles that block the oil pump strainer, starving the engine of lubrication. Peugeot recommends belt inspection every 20,000 km or 1 year, with replacement at 60,000 miles or 6 years. Peugeot's Customer Support Programme covers 100% of costs for oil pressure issues from premature timing belt degradation, up to 10 years or 112,000 miles.

• Wet belt degrades and sheds rubber particles into oil system
• Oil pump strainer blocks, triggering dashboard warning
• Stop driving immediately if warning appears
• Check eligibility for Peugeot's Customer Support Programme

Replacing a Peugeot 3008 1.2 PureTech engine is usually worthwhile if the vehicle is otherwise sound. A rebuilt unit costs **£1,200-£3,200** versus **£6,000-£18,000** for a comparable used 3008. With Peugeot dealer replacement exceeding **£6,500**, specialist rebuilt units offer exceptional value. Check eligibility for Peugeot's Customer Support Programme - some repairs may be covered at 100% for up to 10 years / 112,000 miles.

• Rebuilt engine: £1,200-£3,200
• Comparable used 3008: £6,000-£18,000
• Peugeot dealer replacement: £4,500-£6,500+

With proper maintenance, Peugeot 3008 1.2 PureTech engines typically reach **100,000-150,000 miles**. However, the wet belt is the critical lifespan limiter - Peugeot recommends replacement at **60,000 miles or 6 years**, whichever comes first. Regular oil changes with correct PSA-approved oil and belt inspections are essential for longevity. Some owners report belt failures as early as 45,000 miles.

• Wet belt replacement at 60,000 miles / 6 years
• Oil changes critical to prevent belt degradation
• Check for oil consumption issues

The EB2ADT is the **110hp** 1.2 PureTech fitted to Access, Active and base Allure trims. The EP5/HNS (also known as EB2ADTS) is the **130hp** 1.2 PureTech fitted to Allure 130, GT Line and GT trims. Both use the same 1.2L (1,199cc) three-cylinder turbocharged architecture and share the wet belt vulnerability. The 130hp variant commands a higher replacement cost due to its higher-spec calibration and turbocharger.

• EB2ADT: 110hp, base/mid-spec trims
• EP5/HNS (EB2ADTS): 130hp, higher-spec trims
• Both share the same wet belt design and vulnerabilities

Your Peugeot 3008 1.2 PureTech engine code appears on the VIN plate under the bonnet, stamped on the engine block, or on your V5C registration document section D.2. Common codes include **EB2ADT** (110hp), **EP5** (130hp) and **HNS (EB2ADTS)** (130hp). Enter your reg above for instant verification.

• VIN plate under bonnet shows engine code
• V5C section D.2 lists the official engine code
• EB2ADT = 110hp; EP5 / HNS = 130hp